Grizzly H3098 Manual de usuario descargar pdf (Pagina 11)

H3098 Western Guitar Kit -9-

The position mark holes have been predrilled into

the side of the fingerboard.

To install the position marks:

1. Place a small drop of glue in each position

mark hole.

2. Slide the end of the position mark stick into a

hole and use a sharp knife to cut it flush with

the fingerboard. Note—Sand the position

marks flush with the fingerboard edge.

To attach the fingerboard to the neck:

1. Using a straightedge, make sure the neck

and body surface are flush.

2. Using rubber bands and small sticks of

wood, secure the fingerboard to the neck

with a thin, even layer of wood glue (Figure

7). Note—Make sure the fingerboard is cen-

tered across the width of the neck and that

the 14th fret is centered over the neck to

body joint.

3. Using a file or sandpaper, make the edge of

the neck flush with the edge of the finger-

board.

Fingerboard to NeckPosition Marks

Figure 7. Securing the fingerboard to the neck.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sin comentarios

Grizzly H3098 Manual de usuario Pagina 11